Vehicle
Wiring Details for your
2007-2011 Chevrolet Silverado Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2007-2011 Chevrolet Silverado . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
RED/WHITE (+) (X4) |
@ BCM, BLACK PLUG, PINS 1,2,3 and 4, SEE NOTE #2 |
| STARTER |
SEE NOTE #1 |
|
| STARTER
2 |
N/A |
|
| IGNITION
1 |
PINK (+) |
@ IGNITION SWITCH HARNESS or BCM, LT. GREEN PLUG, PIN 14, SEE NOTE #2 |
| IGNITION
2 |
N/A |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
BROWN or YELLOW (+) |
@ IGNITION SWITCH HARNESS or BCM, LT. GREEN PLUG, PIN 21, SEE NOTE #2 |
| ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
LT. BLUE (-) |
@ HEADLIGHT SWITCH or BCM, WHITE PLUG, PIN 8, SEE NOTE #2 |
| PARKING
LIGHTS ( + ) |
N/A |
|
| POWER LOCK |
SEE NOTE #1 |
|
| POWER UNLOCK |
SEE NOTE #1 |
|
| DOOR TRIGGER |
GRAY/BLACK (-) SEE NOTE #3 |
(ON BASE MODELS) @ BCM, PINK PLUG, PIN 10, SEE NOTE #2 |
| DOMELIGHT
SUPERVISION |
GRAY(DOME LIGHT)(+), WHITE/BLACK(CARGO LIGHT) (+) |
@ BCM, WHITE PLUG, PIN 5 OR PINK PLUG, PIN 2, SEE NOTE #2 |
| TRUNK RELEASE |
N/A |
|
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
TAN (-) |
@ HORN SWITCH or BCM, BROWN PLUG, PIN 18, SEE NOTE #2 |
| TACH |
Any wire NOT PINK, PINK/BLACK or PINK/WHITE (AC), SEE NOTE #4 |
@ ANY FUEL-INJECTOR |
| WAIT TO
START LIGHT |
DK. BLUE (-) |
@ INSTRUMENT CLUSTER, BLACK 20-PIN PLUG, PIN 17 |
| BRAKE |
LT. BLUE/WHITE (+) (TEST WITH IGNITION ON) |
@ BRAKE PEDAL SWITCH or BCM, BROWN PLUG, PIN 6, SEE NOTE #2 |
| FACTORY
ALARM DISARM |
LT. GREEN (-) SEE NOTE #5 |
On BASE Model @ BCM, PINK PLUG, PIN 20, SEE NOTE #2 |
| ANTI-THEFT |
GM'S MULTIPLEX IGNITION/ANTI-THEFT SYSTEM, See NOTE #1 |
|
| EXTRA
INFORMATION |
| NOTE #1: This vehicle REQUIRES a Special INTERFACE BYPASS MODULE for REMOTE STARTING
AND for KEYLESS ENTRY Installation, you MUST USE the INTERFACE BYPASS MODULE,
Part # DB-ALL or XK09, EITHER Bypass will do the Anti-theft and Keyless entry, either
Bypass Module will also require Part # RFLCHGM,
to order go to the INTERFACE BYPASS MODULE Page on this website.
NOTE #2: The BCM is located UNDER the Drivers Side of the Dash and to the LEFT of the
Steering Column.
NOTE #3: On Premiun Models this wire is located at the Drivers Window Switch, BROWN
16-PIN PLUG, PIN 13
NOTE #4: On DIESELS use the DK. BLUE/WHITE @ the CAM SHAFT POSITION SENSOR, GRAY
3-PIN PLUG, PIN 1 or at the ECM, BLACK, 96-PIN PIN PLUG, PIN 56. The Cam shaft
Position Sensor is located on the Front of the engine, above the crank pulley. The
ECM, is located at the Left Front of the engine compartment, near the Fan Shroud.
NOTE #5: On PREMIUM Models, this wire is located at the Driver Window Switch, BROWN, 16-PIN
PLUG, PIN 4, on the Base or Premium model, TEST this wire while turning the key in
the drivers door key cylinder.
|
|
|
|
|
|
