| PART | COLOR | LOCATION |
| 12 VOLT CONSTANT | RED/WHITE (+) (X4) | @ BCM, BLACK PLUG, PINS 1,2,3 and 4, SEE NOTE #2 |
| STARTER | SEE NOTE #1 | |
| STARTER 2 | N/A | |
| IGNITION 1 | PINK (+) | @ IGNITION SWITCH HARNESS or BCM, LT. GREEN PLUG, PIN 14, SEE NOTE #2 |
| IGNITION 2 | N/A | |
| IGNITION 3 | N/A | |
| ACCESSORY/HEATER BLOWER 1 | BROWN or YELLOW (+) | @ IGNITION SWITCH HARNESS or BCM, LT. GREEN PLUG, PIN 21, SEE NOTE #2 |
| ACCESSORY/HEATER BLOWER 2 | N/A | |
| KEYSENSE | N/A | |
| PARKING LIGHTS ( - ) | LT. BLUE (-) | @ HEADLIGHT SWITCH or BCM, WHITE PLUG, PIN 8, SEE NOTE #2 |
| PARKING LIGHTS ( + ) | N/A | |
| POWER LOCK | SEE NOTE #1 | |
| POWER UNLOCK | SEE NOTE #1 | |
| DOOR TRIGGER | GRAY/BLACK (-) SEE NOTE #3 | (ON BASE MODELS) @ BCM, PINK PLUG, PIN 10, SEE NOTE #2 |
| DOMELIGHT SUPERVISION | GRAY(DOME LIGHT)(+), WHITE/BLACK(CARGO LIGHT) (+) | @ BCM, WHITE PLUG, PIN 5 OR PINK PLUG, PIN 2, SEE NOTE #2 |
| TRUNK RELEASE | N/A | |
| SLIDING POWER DOOR | N/A | |
| HORN | TAN (-) | @ HORN SWITCH or BCM, BROWN PLUG, PIN 18, SEE NOTE #2 |
| TACH | Any wire NOT PINK, PINK/BLACK or PINK/WHITE (AC), SEE NOTE #4 | @ ANY FUEL-INJECTOR |
| WAIT TO START LIGHT | DK. BLUE (-) | @ INSTRUMENT CLUSTER, BLACK 20-PIN PLUG, PIN 17 |
| BRAKE | LT. BLUE/WHITE (+) (TEST WITH IGNITION ON) | @ BRAKE PEDAL SWITCH or BCM, BROWN PLUG, PIN 6, SEE NOTE #2 |
| FACTORY ALARM DISARM | LT. GREEN (-) SEE NOTE #5 | On BASE Model @ BCM, PINK PLUG, PIN 20, SEE NOTE #2 |
| ANTI-THEFT | GM'S MULTIPLEX IGNITION/ANTI-THEFT SYSTEM, See NOTE #1 |
| EXTRA INFORMATION |
| NOTE #1: This vehicle REQUIRES a Special INTERFACE BYPASS MODULE for REMOTE STARTING AND for KEYLESS ENTRY Installation, you MUST USE the INTERFACE BYPASS MODULE, Part # DB-ALL or XK09, EITHER Bypass will do the Anti-theft and Keyless entry, either Bypass Module will also require Part # RFLCHGM, to order go to the INTERFACE BYPASS MODULE Page on this website. NOTE #2: The BCM is located UNDER the Drivers Side of the Dash and to the LEFT of the Steering Column. NOTE #3: On Premiun Models this wire is located at the Drivers Window Switch, BROWN 16-PIN PLUG, PIN 13 NOTE #4: On DIESELS use the DK. BLUE/WHITE @ the CAM SHAFT POSITION SENSOR, GRAY 3-PIN PLUG, PIN 1 or at the ECM, BLACK, 96-PIN PIN PLUG, PIN 56. The Cam shaft Position Sensor is located on the Front of the engine, above the crank pulley. The ECM, is located at the Left Front of the engine compartment, near the Fan Shroud. NOTE #5: On PREMIUM Models, this wire is located at the Driver Window Switch, BROWN, 16-PIN PLUG, PIN 4, on the Base or Premium model, TEST this wire while turning the key in the drivers door key cylinder. |