| PART | COLOR | LOCATION |
| 12 VOLT CONSTANT | RED (+) | @ BATTERY or TIPM, Note #2 |
| STARTER | SEE NOTE #1 | |
| STARTER 2 | N/A | |
| IGNITION 1 | PINK/WHITE (+) | @ WIRELESS IGNITION NODE (12-PIN PLUG) PIN 3, Note #3 |
| IGNITION 2 | N/A | |
| IGNITION 3 | N/A | |
| ACCESSORY/HEATER BLOWER 1 | SEE NOTE #1 | |
| ACCESSORY/HEATER BLOWER 2 | N/A | |
| KEYSENSE | N/A | |
| PARKING LIGHTS ( - ) | WHITE/BROWN (-) thru a 1000 Ohm Resistor Must use a relay to isolate (5-wire) white/brown wire from switch while triggering | @ HEADLIGHT SWITCH or INSTRUMENT CLUSTER(PLUG(C2) PIN 9 |
| PARKING LIGHTS ( + ) | LT. BLUE(+) (Left) and WHITE/PURPLE(+) (Right) | in DRIVERS KICK PANEL or TIPM (PLUG(C5) PINS 8 and 36, Note #2 |
| POWER LOCK | PURPLE/DK. GREEN (-) thru a 330 Ohm Resistor (Base Models) | in DRIVERS KICK PANEL or TIPM (PLUG(C7) Pin 2, Note #2 |
| POWER UNLOCK | Use LOCK wire, (-) thru a 100 Ohm Resistor, Note #4 | |
| DOOR TRIGGER | PURPLE (-) | in DRIVERS KICK PANEL or TIPM (PLUG(C7) Pin 11, Note #2 |
| DOMELIGHT SUPERVISION | YELLOW/PURPLE (+) | @ PASSENGER A PILLAR or INSTRUMENT CLUSTER(PLUG(C2) PIN 4 |
| TRUNK RELEASE | PURPLE/TAN (-) thru a Resistor (Power Liftgate) | @ Power Liftgate Switch or PLM, (22-PIN PLUG) PIN 14, Note #5 |
| SLIDING POWER DOOR | PURPLE/DK. BLUE (-) thru a Resistor (Power Liftgate) Note #6 | @ SLIDING DOOR Switch or INSTRUMENT CLUSTER (PLUG(C2) PIN 1 |
| HORN | DK. GREEN/PURPLE (-) | @ HORN SWITCH or INSTRUMENT CLUSTER(PLUG(C3) PIN 10 |
| TACH | Any wire NOT BROWN/WHITE (AC) | @ Any FUEL-INJECTOR |
| WAIT TO START LIGHT | N/A | |
| BRAKE | WHITE/DK. GREEN (+) | @ BRAKE SWITCH or TIPM (PLUG(C7) Pin 10, Note #2 |
| FACTORY ALARM DISARM | DISARMS with FACTORY REMOTE ONLY!! | |
| ANTI-THEFT | CHRYSLER'S MULTIPLEX IGNITION/ANTI-THEFT SYSTEM, See NOTE #1 |
| EXTRA INFORMATION |
| NOTE #1: This Vehicle is Equipped with CHRYSLERS MULTIPLEX IGNITION/ANTI-THEFT SYSTEM that requires a INTERFACE BYPASS MODULE Part # DB-ALL or XK09 for REMOTE STARTING and for the KEYLESS ENTRY, when using the Interface Bypass the Resistors for the Door Locks is no longer needed, either of these Modules will work for this vehicle, to order go to the INTERFACE BYPASS MODULE Page on this website. Note #2: the TIPM (Totally Integrated Power Modlue) is located in the Engine Compartment, on the Drivers side. Note #3: the WIRELESS IGNITION NODE is part of the IGNITION Switch. Note #4: on all other models use the LT. GREEN/WHITE (-) @ the PASSENGER DOOR Lock Switch or the PDM( Passenger door Module) PLUG (C5) PIN 4. The PDM is located in the Passenger Door. Note #5: the PLM (Power Liftgate Module) is located in the Driver side Rear Quarter Panel. Note #6: You can also use a PURPLE/DK. GREEN (-) @ the LEFT "B" Pillar Switch or TIPM (PLUG(C7) PIN 36. |