| PART | COLOR | LOCATION |
| 12 VOLT CONSTANT | WHITE/BLUE (+) and RED (+) | @ IGNITION SWITCH HARNESS |
| STARTER | GREEN/BLACK (+) | @ IGNITION SWITCH HARNESS |
| STARTER 2 | N/A | |
| IGNITION 1 | BLACK/RED (+) | @ IGNITION SWITCH HARNESS |
| IGNITION 2 | BLUE/YELLOW (+) | @ IGNITION SWITCH HARNESS |
| IGNITION 3 | N/A | |
| ACCESSORY/HEATER BLOWER 1 | WHITE/GREEN (+) | @ IGNITION SWITCH HARNESS |
| ACCESSORY/HEATER BLOWER 2 | N/A | |
| KEYSENSE | GREEN/YELLOW (-) See NOTE #2 | @ IGNITION SWITCH HARNESS |
| PARKING LIGHTS ( - ) | GREEN (-) | @ BECU, TOP PLUG, PIN 8, See NOTE #3 |
| PARKING LIGHTS ( + ) | GREEN (+) | @ 16-PIN PLUG, LEFT of FUSES |
| POWER LOCK | BLUE (TYPE B) | IN DRIVERS KICK, 18-PIN PLUG |
| POWER UNLOCK | GREEN (TYPE B) (Requires Double Pulse) | IN DRIVERS KICK, 18-PIN PLUG |
| DOOR TRIGGER | PURPLE/YELLOW (-) | @ BECU, TOP PLUG, PIN 12, See NOTE #3 |
| DOMELIGHT SUPERVISION | WHITE (-), (Requires Part #775 Relay) | @ PIN 8, PLUG TO RIGHT OF OF FUSEBOX |
| TRUNK RELEASE | N/A | |
| SLIDING POWER DOOR | N/A | |
| HORN | GREEN/RED (-) | @ STEERING COLUMN HARNESS |
| TACH | BLACK/WHITE (AC) | @ ECM, Connector E8, pin 5, See NOTE #4 |
| WAIT TO START LIGHT | N/A | |
| BRAKE | GREEN/YELLOW (+) | @ SWITCH ABOVE BRAKE PEDAL |
| FACTORY ALARM DISARM | DISARMS WITH UNLOCK or See NOTE #2 | |
| ANTI-THEFT | TOYOTA'S TRANSPONDER ANTI-THEFT SYSTEM, SEE NOTE #1 | @ IGNITION SWITCH TUMBLER |
| EXTRA INFORMATION |
| NOTE #1: TOYOTA'S TRANSPONDER SYSTEM, Requires Bypass Module: (For Remote Starting Only) Part #791 Bypass, (Requires Extra Key) for Operation. (For Remote Starting Only) Part # PK-ALL Bypass. (No Extra Key Required for Operation) 2-KEYS Required to Program Module. To order please go to the SECURITY BYPASS MODULE Page or INTERFACE BYPASS MODULE Page on this website. NOTE #2: you can DISARM without UNLOCKING by sending a negative signal to your green/yellow keysense thru a diode(Radio Shack #276-1103) from the Negative Output While Running wire on remote starter. Connect the UNBANDED END of the diode to the keysense wire. NOTE #3: the BECU (Body Electronic Control Unit), is part of the FUSEBOX, located under the DRIVER SIDE of the DASH, the unit has 3 Plugs that exit the RIGHT side edge of the FUSE BOX, and are for the Body Electronic Control Unit. NOTE #4: the ECM (Engine Control Module) is located BEHIND the GLOVE BOX, Connector E8 is in the BOTTOM PLUG. |