PART | COLOR | LOCATION |
12 VOLT CONSTANT | LIGHT GREEN/PURPLE (+) | @ IGNITION SWITCH HARNESS |
STARTER | RED/LIGHT BLUE (+) | @ IGNITION SWITCH HARNESS |
STARTER 2 | N/A | |
IGNITION 1 | RED/LIGHT GREEN (+) | @ IGNITION SWITCH HARNESS |
IGNITION 2 | BLACK/LIGHT GREEN (+) | @ IGNITION SWITCH HARNESS |
IGNITION 3 | N/A | |
ACCESSORY/HEATER BLOWER 1 | GRAY/YELLOW (+) | @ IGNITION SWITCH HARNESS |
ACCESSORY/HEATER BLOWER 2 | N/A | |
KEYSENSE | N/A | |
PARKING LIGHTS ( - ) | N/A | |
PARKING LIGHTS ( + ) | BROWN (+) | @ HEADLIGHT SWITCH or FUSEBOX |
POWER LOCK | PINK/YELLOW (TYPE B) | @ GEM, 26 Pin Plug, See NOTE *1 |
POWER UNLOCK | PINK/LIGHT GREEN (TYPE B) | @ GEM, 26 Pin Plug, See NOTE *1 |
DOOR TRIGGER | BLACK/LIGHT BLUE (+) | @ TOP plug of FUSEBOX |
DOMELIGHT SUPERVISION | USE DOOR TRIGGER, | |
TRUNK RELEASE | See NOTE *2, Requires Part #775 Relay | @ TRUNK RELEASE SWITCH |
SLIDING POWER DOOR | N/A | |
HORN | PURPLE or BLUE (-) | @ STEERING COLUMN HARNESS |
TACH | TAN/YELLOW (AC0 | @ PCM, See NOTE *3 |
WAIT TO START LIGHT | N/A | |
BRAKE | RED/LIGHT GREEN (+) | @ SWITCH ABOVE BRAKE PEDAL |
FACTORY ALARM DISARM | PINK/WHITE (-) | IN DRIVERS KICK PANEL |
ANTI-THEFT | FORD'S SECURILOCK ANTI-THEFT TRANSPONDER SYSTEM | TRANSPONDER @ IGNITION SWITCH TUMBLER |
EXTRA INFORMATION |
NOTE *1 the GEM (Generic Control Module) is located to the LEFT of the STEERING COLUMN. NOTE *2 On Vehicles with FACTORY KEYLESS ENTRY, the TRUNK Release is a (-) PURPLE/YELLOW wire at the Trunk Release Switch and on vehicle without FACTORY KEYLESS ENTRY, the Trunk Release is a (+) GRAY/RED wire at the Trunk Release Switch. NOTE *3 the PCM (Powertrain Control Module) is located on the Passenger side firewall under the hood. NOTE #4: This vehicle is equipped with a Special Anti-theft key, to remote start you will need a Bypass module 791, use this module IF you have a extra ignition key to place inside the 791 to remote start, if you do not have an extra key to use or wish not to have a key placed inside this bypass module, we OFFER a KEYLESS INTERFACE BYPASS MODULE that does not require a key to be placed inside the bypass module, this is Part # PKALL or PKFM, either one will work, to order, go to the INTERFACE BYPASS MODULE PAGE on this website. |