Vehicle
Wiring Details for your
2010-2011 Kia Soul Wiring Diagram |
Printer Friendly Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2010-2011 Kia Soul . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
|
PART |
COLOR |
LOCATION |
12 VOLT
CONSTANT |
WHITE or RED (+) |
@ IGNITION SWITCH, (BLACK, 6-PIN PLUG), PIN 5 |
STARTER |
BLUE (+) |
@ IGNITION SWITCH, (BLACK, 6-PIN PLUG), PIN 1 |
STARTER
2 |
N/A |
|
IGNITION
1 |
PINK (+) |
@ IGNITION SWITCH, (BLACK, 6-PIN PLUG), PIN 6 |
IGNITION
2 |
N/A |
|
IGNITION
3 |
N/A |
|
ACCESSORY/HEATER
BLOWER 1 |
WHITE (+), NOTE #2 |
@ IGNITION SWITCH, (BLACK, 6-PIN PLUG), PIN 3 |
ACCESSORY/HEATER
BLOWER 2 |
YELLOW (+) |
@ IGNITION SWITCH, (BLACK, 6-PIN PLUG), PIN 4 |
KEYSENSE |
N/A |
|
PARKING
LIGHTS ( - ) |
PINK (-) |
@ HEADLIGHT SWITCH, (WHITE, 13-PIN PLUG), PIN 1 |
PARKING
LIGHTS ( + ) |
GREEN/BLACK(+)(Left) and YELLOW/BLACK(+)(Right), use both!! |
@ DASH FUSE BOX, (REAR BLUE, 22-PIN PLUG(I), PINS 17 and 16 |
POWER LOCK |
BROWN (TYPE B) |
in DRIVERS KICK PANEL, (WHITE, 26-PIN PLUG), PIN 10 |
POWER UNLOCK |
GREEN (TYPE B), NOTE #3 |
in DRIVERS KICK PANEL, (WHITE, 26-PIN PLUG), PIN 18 |
DOOR TRIGGER |
GREEN (-) |
in PASSENGER KICK PNEL, (WHITE, 26-PIN PLUG), PIN 16 |
DOMELIGHT
SUPERVISION |
BLUE (-) |
in DRIVERS KICK PANEL, (WHITE, 26-PIN PLUG), PIN 14 |
TRUNK RELEASE |
PINK (-), NOTE #4 |
in DRIVERS KICK PANEL, (WHITE, 26-PIN PLUG), PIN 1 |
SLIDING
POWER DOOR |
N/A |
|
HORN |
GRAY (-) |
Above DRIVERS KICK PANEL, (BLUE, 39-PIN PLUG), PIN 29 |
TACH |
GREEN, (AC) |
Above DRIVERS KICK PANEL, (BLUE, 39-PIN PLUG), PIN 17 |
WAIT TO
START LIGHT |
N/A |
|
BRAKE |
RED/ORANGE (+) |
Above DRIVERS KICK PANEL, (WHITE, 14-PIN PLUG), PIN 7 |
FACTORY
ALARM DISARM |
GRAY (-) and YELLOW (-) NOTE #5 |
in DRIVERS KICK PANEL, (WHITE, 26-PIN PLUG), PINS 13 and 23 |
ANTI-THEFT |
KIA'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1 |
@ IGNITION SWITCH TUMBLER |
EXTRA
INFORMATION |
NOTE #1: This vehicle May Be Equipped with KIA'S TRANSPONDER ANTI-THEFT SYSTEM,
check the OWNERS MANUAL for this vehcile or contact your HYUNDAI Dealer to see if
the vehicle has a Special programmed Ignition Key, if it does, then for REMOTE
STARTING you will need the 791 BYPASS Module and an Extra Ignition key.
To Order the 791 go to the SECURITY BYPASS MODULE Page on this website.
NOTE #2: this wire may need to be RELAY ISOLATED to prevent STARTER GRIND upon
KEY take over.
NOTE #3: to UNLOCK just the DRIVERS DOOR, use the BROWN (-), at the DASH FUSE
BOX, (REAR WHITE, 20-PIN PLUG(D), PIN 1
NOTE #4: TEST this wire while Opening the TAILGATE with the Handle on the REAR of the Vehicle.
NOTE #5: to DISARM, use the GRAY (-) and the YELLOW (-) use both wires, and DIODE ISOLATE
will Require a Double Pulse. TEST these wires while turning the KEY in the Drivers Door.
|
|
|
|
|