Vehicle
Wiring Details for your
2008-2011 Mitsubishi Lancer Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2008-2011 Mitsubishi Lancer . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
WHITE (+) |
@ FUSE BOX, (BLACK, 2-PIN PLUG), PIN 1 |
| STARTER |
ORANGE (+) |
@ IGNITION SWITCH, (WHITE, 6-PIN PLUG), PIN 5 |
| STARTER
2 |
N/A |
|
| IGNITION
1 |
WHITE (+) |
@ IGNITION SWITCH, (WHITE, 6-PIN PLUG), PIN 2 |
| IGNITION
2 |
N/A |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
LT. GREEN (+) |
@ IGNITION SWITCH, (WHITE, 6-PIN PLUG), PIN 6 |
| ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
N/A |
|
| PARKING
LIGHTS ( + ) |
YELLOW (+)(Left) and BROWN (+)(Right), (Requires 775 relay) NOTE #2 |
@ FUSE BOX, (WHITE, 20-PIN PLUG), PINS 10 and 13 |
| POWER LOCK |
YELLOW/RED (TYPE B) |
in DRIVERS KICK PANEL, (BROWN, 24-PIN PLUG), PIN 2 |
| POWER UNLOCK |
GRAY (TYPE B) |
in DRIVERS KICK PANEL, (BROWN, 24-PIN PLUG), PIN 3 |
| DOOR TRIGGER |
YELLOW (-) |
@ FUSE BOX, (BROWN, 16-PIN PLUG), PIN 16 |
| DOMELIGHT
SUPERVISION |
YELLOW (-) |
in DRIVERS A Pillar or FUSE BOX, (WHITE, 6-PIN PLUG), PIN 5 |
| TRUNK RELEASE |
Use TRUNK RELEASE Motor |
|
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
GREEN (-) |
@HORN SWITCH or FUSE BOX, (WHITE, 19-PIN PLUG), PIN 19 |
| TACH |
Any wire NOT RED/WHITE(Non-Turbo) or RED/BLACK(Turbo) (AC) |
@ any FUEL-INJECTOR |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
RED (+) |
@ BRAKE PEDAL SWITCH or in DRIVERS KICK PANEL, Harness to REAR of Vehicle |
| FACTORY
ALARM DISARM |
DISARMS with FACTORY REMOTE ONLY! |
|
| ANTI-THEFT |
MITSUBISHI'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1 |
TRANSPONDER @ IGNITION SWITCH TUMBLER |
| EXTRA
INFORMATION |
| NOTE #1: MITSUBISHI'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module,
Part # 791 Bypass Module (for REMOTE STARTING ONLY!) an Extra Ignition key is
required to be placed inside this module for Operation.
Part # XK09 Bypass Module, this Module is a KEYLESS BYPASS MODULE and DOES
NOT require a Key to be placed inside the Module for Operation.
To order go to the INTERFACE BYPASS MODULE Page on this website.
NOTE #2: the PARKING LIGHT wires on the LANCER EVOLUTION are YELLOW(+)(Left) and
GRAY(+)(Right) same locations.
|
|
|
|
|
|
