Vehicle Wiring Details for a
2002 Saturn S-Series
Item Wire Color Polarity Wire Location
12V red Positive (+) ignition harness
Starter yellow Positive (+) ignition harness
Starter 2 none
Ignition pink Positive (+) ignition harness
2nd Ignition none
3rd Ignition none
Accessory orange Positive (+) ignition harness
Accessory 2 brown Positive (+) ignition harness
Tachometer white or orange ignition module [2]
Power Door (Lock)
Wiring Diagram for
[Positive (+)] Door Lock		 lt. blue Positive (+) drivers kick panel
Power Door (Unlock)
Wiring Diagram for
[Positive (+)] Door Unlock		 white Positive (+) drivers kick panel
Door Trigger [1] Negative (-) [1]
Dome Supervision
Wiring Diagram for
[] Dome		 use door trigger
Headlights blue [4] Negative (-) headlight switch
Parklight Positive brown Positive (+) headlight switch
Parklight Negative none
Wipers brown(L), purple(H) Negative (-) steering column
Left Front Window
(Up/Down)		 dk blue - brown switch in center console
Right Front Window
(Up/Down)		 lt blue - tan switch in center console
Left Rear Window
(Up/Down)		 dk green - purple A switch in center console
Right Rear Window
(Up/Down)		 lt green - purple A switch in center console
Trunk/Hatch Pin orange/black Negative (-) [3]
Hood Pin none
Trunk/Hatch Release
Wiring Diagram for
[Positive (+)] Trunk/Hatch		 gray or black Positive (+) behind fuse box
Factory Alarm
(Arm)		 none
Factory Alarm
(Disarm) 		none
Horn black Negative (-) steering column
Brake lt blue Positive (+) brake pedal switch
Door Motor
(Lock) 		gray drivers kick panel
Door Motor
(Unlock)		 tan drivers kick panel
Disarm tan passengers kick panel
Disarm No Unlock none
Additional Info:
This vehicle has the passlock II immobilizer system that, when adding a remote start, must be interfaced with. Use Commando part PassMod. The lt. green key sense wire at the steering column must see a ground during remote start to keep the "SERVICE" light from coming on. [1] Use gray/black for the drivers door and lt. green/black for the passenger door(s). The gray/black is located near the diagnostic plug harness under the drivers side of the dash, and the lt. green/black is located in a black 24 pin plug behind the fuse box in the center console. Use both wires and diode isolate each. [2] Ignition module is on the center front of the motor. Can also find tach at the PCM located behind the battery. [3] On vehicles without power door locks go to the light in the trunk. On vehicles with power door locks can find the wire in a gray 68 pin plug behind the fuse box in the center console. [4] Low beam is high current negative, must use relay.

ATTENTION: This wiring information is being provided free of charge and on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it by using a digital multimeter. GNU Industries, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. GNU assumes no responsibility resulting from an improper installation, even in reliance upon this information.

Copyright © 2000-2006 GNU Industries, Inc. All Rights Reserved.
一般æ¥è®²ï¼Œå¥³äººè¿‡äº†å‘育期丰胸产å“，想è¦ä¸°èƒ¸å°±ä¼šæ¯”较困难，ä¸è¿‡ä¹Ÿä¸æ˜¯ä¸è¡Œèƒ½çš„粉嫩公主酒酿蛋，这个时候需è¦å€ŸåŠ©ä¸“业的丰胸产å“，而且是å¥åº·æœ‰æ•ˆçš„丰胸产å“丰胸食物。添加WeChat获å–å…费一对一丰胸指导丰胸效果ï¼