NOTE #1: When Installing a REMOTE STARTER, you MUST use BOTH Starter #1 and Starter #2
wires. Both wires must be connected to the STARTER/CRANKING Output wire from the
Remote Starter or the vehcile will NOT Remote Start when the Engine is cold.
NOTE #2: On vehicles with DLR, use the GRAY/GREEN (+) at the HEADLIGHT SWITCH, use a
RELAY to isolate this wire use the DIAGRAM 5-WIRE ISOLATION on the (-) PARKING
LIGHTS INFO. On vehicles without the DRL, use the GREEN/BLACK (+) and GREEN/RED
(+) wires at the HEADLIGHT SWITCH and use the DIAGRAM DAUL PARKING LIGHT
NOTE #3: the FACTORY KEYLESS ENTRY MODULE is located under the DRIVERS side floor mat
in front of the DRIVERS SEAT.
NOTE #4: IGNITION CONTROLLED DOOR LOCK will cause problems with the door locks
DO NOT USE!!!
NOTE #5: DRIVERS DOOR TRIGGER IS GREENYELLOW (-) IN CONNECTOR 5 PIN 1, FRONT
PASSANGER DOOR IS RED/GRAY (-) IN C5, PIN10 LEFT REAR DOOR IS BLACK/RED
(-) IN C5 PIN 12 ,AND RIGHT REAR DOOR IS BLACK/PURPLE (-) IN C5 PIN 14
WHEN CONNECTING TO AN ALARM SYSTEM USE ALL 4 WIRES AND DIODE ISOLATE
SEE DIAGRAM
NOTE #6: AUDI'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module,
Part # 791 Bypass and an extra ignition key for REMOTE STARTING
Operation.
To order go to the SECURITY BYPASS MODULE Page on the website.
|